TR BY Label Layout and Requirements for Belarus (TR 2018/024/BY) | WWG
Technical regulation of Belarus “Means of telecommunication. Security” (TR 2018/024/BY) came into force on January 1, 2019. It contains obligatory procedure for certification and declaration of the telecommunication means.
Products that are compliant with this TR should be labeled accordingly.
Below are label requirements and label itself for TR 2018/024/BY from the Resolution of the Council of Ministers of the Republic of Belarus No. 383 from May 24, 2017.
The mark of conformity with the Technical Regulation of the Republic of Belarus is a combination of the letters "T" and "P" located inside an enclosing round-edged border interrupted by the symbol "BY". The size of the Conformity Mark shall guarantee that its elements are clearly visible and legible with the naked eye on the general colored background of the product. It can be affixed by any method ensuring its visibility and legibility within the entire service/shelf life of the product.
The Conformity Mark can be affixed to the product itself near the information about the manufacturer; as a rule, it shall be affixed on the product's fixed part and shall be displayed in the attached operation documents.
It also may be affixed to the smallest consumer packing/container and specified in the operation documents attached to the product, where it is impossible to affix it to the product itself due to product size or type. Where such products have no packing, the Conformity Mark shall be displayed in the attached operation documents.
Where other marks of conformity are affixed to the product, they shall not worsen the visibility, clarity and legibility of the Conformity Mark.
Image of the Mark of Conformity with the Technical Regulation of the Republic of Belarus in the Graduated Drawing
- "a" is a grid line step
- The dimensions of the Conformity Mark shall be defined by choosing a basic dimension H based on a grid line step a
- The minimum value of the basic dimension H shall be 5 mm
- The size of the image of the Conformity Mark shall be proportionate to the basic dimension H.
Read about EAC marking
Please send your requests to email@example.com